matched gaas spdt switch, dc - 3.0 ghz with ttl/cmos control input rev. v6 sw - 313 - pin 1 1 m/a - com technology solutions inc. (macom) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. visit www.macom.com for additional data sheets and product information. for further information and support please visit: https://www.macom.com/support 1 features ? integral ttl driver ? low dc power consumption ? fast switching speed: 7 ns typical ? hermetic surface mount package ? 50 ohm nominal impedance ? mil - std - 883 screening available ? lead - free cr - 9 package ? 260c reflow compatible ? rohs* compliant description m/a - coms sw - 313 - pin is a gaas fet spdt ab- sorptive switch with integral silicon asic driver. packaged in a 16 - lead ceramic surface mount pack- age, this device offers excellent performance and repeatability from dc to 3 ghz while maintaining low power consumption. the sw - 313 - pin is ideally suited for use where fast speed, low power con- sumption and broadband applications are required. mil - std - 883 screening available. ordering information part number package sw - 313 - pin bulk packaging sw - 313 - tb sample test board note: reference application note m513 for reel size information. functional block diagram pin configuration pin no. function pin no. function 1 vee 9 rfc 2 gnd 10 gnd 3 gnd 11 gnd 4 gnd 12 rf1 5 rf2 13 gnd 6 gnd 14 gnd 7 gnd 15 vcc 8 gnd 16 c1 * restrictions on hazardous substances, european union directive 2002/95/ec. the metal bottom of the case must be connected to rf and dc ground. r f c g n d g n d r f 1 g n d g n d g n d g n d g n d r f 2 g n d g n d g n d o r i e n t a t i o n m a r k v e e v c c c 1
matched gaas spdt switch, dc - 3.0 ghz with ttl/cmos control input rev. v6 sw - 313 - pin 2 2 m/a - com technology solutions inc. (macom) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. visit www.macom.com for additional data sheets and product information. for further information and support please visit: https://www.macom.com/support 2 electrical specifications: (from C 55c to +85c), z 0 = 50 ? 1 ,2 parameter frequency units min typ max test conditions insertion loss dc - 3000 mhz dc - 2000 mhz dc - 1000 mhz dc - 500 mhz db db db db 1.2 1.1 0.9 0.8 vswr dc - 3000 mhz dc - 2000 mhz dc - 1000 mhz dc - 500 mhz ratio ratio ratio ratio 1.50:1 1.40:1 1.35:1 1.30:1 isolation dc - 3000 mhz dc - 2000 mhz dc - 1000 mhz dc - 500 mhz db db db db 35 43 48 53 trise, tfall ns 7 10% to 90% ton, toff ns 18 1.3v ctl to 90% / 10% transients mv 25 in - band 1 db compression 0.05 ghz 0.5 ghz to 3 ghz dbm dbm +25 +30 input power ip2 0.05 ghz 0.5 ghz to 3 ghz dbm dbm +60 +65 two - tone input power up to +5 dbm ip3 0.05 ghz 0.5 ghz to 3 ghz dbm dbm +40 +46 two - tone input power up to +5 dbm vin low 0v to 0.8v a 1 vin high 2.0v to 5.0v a 1 vcc +5.0v 10% ma 1 vee - 5.0v to - 8.0v ma 1 1. all specifications apply when operated with bias voltages of +5v for vcc and C 5v for vee. 2. when dc blocks are used, a 10k ohm return to gnd is required on the rfc port.
matched gaas spdt switch, dc - 3.0 ghz with ttl/cmos control input rev. v6 sw - 313 - pin 3 3 m/a - com technology solutions inc. (macom) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. visit www.macom.com for additional data sheets and product information. for further information and support please visit: https://www.macom.com/support 3 absolute maximum ratings 3,4 parameter absolute maximum max input power 50 mhz 500 - 3000 mhz +27 dbm +34 dbm v cc - 0.5v v cc +7.0v v ee - 8.5v v ee +0.5v v cc - v ee - 0.5v v cc - v ee 14.5v vin 5 - 0.5v vin v cc + 0.5v operating temperature - 55c to +125c storage temperature - 65c to +150c 3. exceeding any one or combination of these limits may cause permanent damage to this device. 4. m/a - com does not recommend sustained operation near these survivability limits. 5. standard cmos ttl interface, latch - up will occur if logic signal is applied prior to power supply. handling procedures please observe the following precautions to avoid damage: static sensitivity gallium arsenide integrated circuits are sensitive to electrostatic discharge (esd) and can be damaged by static electricity. proper esd control techniques should be used when handling these devices. truth table (switch) condition of switch control input rf common to each rf port c1 rf1 rf2 0 on off 1 off on isolation vs. frequency 0 = ttl low; 1 = ttl high typical performance curves insertion loss vs. frequency vswr vs. frequency 0 10 20 30 40 50 60 70 80 0.0 0.5 1.0 1.5 2.0 2.5 3 f re que nc y ( g h z) isolation db 0.00 0.50 1.00 1.50 2.00 0.0 0.5 1.0 1.5 2.0 2.5 3 f re que nc y ( g h z) loss (db) 1.00 1.20 1.40 1.60 1.80 2.00 2.20 0.0 0.5 1.0 1.5 2.0 2.5 3 f re que nc y ( g h z) vswr v sw r ( on) v sw r ( of f )
matched gaas spdt switch, dc - 3.0 ghz with ttl/cmos control input rev. v6 sw - 313 - pin 4 4 m/a - com technology solutions inc. (macom) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. visit www.macom.com for additional data sheets and product information. for further information and support please visit: https://www.macom.com/support 4 lead - free, cr - 9 ceramic package ? ? reference application note m538 for lead - free solder reflow recommendations.
matched gaas spdt switch, dc - 3.0 ghz with ttl/cmos control input rev. v6 sw - 313 - pin 5 5 m/a - com technology solutions inc. (macom) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. visit www.macom.com for additional data sheets and product information. for further information and support please visit: https://www.macom.com/support 5 m/a - com technology solutions inc. all rights reserved. information in this document is provided in connection with m/a - com technology solutions inc ("macom") products. these materials are provided by macom as a service to its customers and may be used for informational purposes only. except as provided in macom's terms and conditions of sale for such products or in any separate agreement related to this document, macom assumes no liability whatsoever. macom assumes no responsibility for errors or omissions in these materials. macom may make changes to specifications and product descriptions at any time, without notice. macom makes no commitment to update the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future changes to its specifications and product descriptions. no license, express or implied, by estoppels or otherwise, to any intellectual property rights is granted by this document. these materials are provided "as is" without warranty of any kind, either express or implied, relating to sale and/or use of macom products including liability or warranties relating to fitness for a particular purpose, consequential or incidental damages, merchantability, or infringement of any patent, copyright or other intellectual property right. macom further does not warrant the accuracy or completeness of the information, text, graphics or other items contained within these materials. macom shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use of these materials. macom products are not intended for use in medical, lifesaving or life sustaining applications. macom customers using or selling macom products for use in such applications do so at their own risk and agree to fully indemnify macom for any damages resulting from such improper use or sale.
|
